Trimble Support Videos

Roll Calibration - FMX

Watch this video to learn how to correctly calibrate the roll compensation on a Trimble Autopilot system. This will solve the common “wide/narrow middles” issue.

Exporting Guidance Lines from GFX for FMX

This video shows how to export guidance lines from a GFX750 display to be used on a FMX or CFX display.

Creating an Implement in PIQ

Watch here to learn how to create an implement in Trimble’s Precision IQ operating system on the GFX350, GFX750, and TMX2050 displays.

Setting up an Implement on an FMX

Watch this video to learn how to setup an implement on an FMX display or a TMX2050 display running the FMX+ operating system.

Precision Planting Support Videos

Gen1 and Gen2 2020 Planter Setup

Watch this video to learn how to setup a new planter in your Gen1 or Gen2 2020 display.

vDrive and RowFlow Swath Callibration

Learn how to calibrate the shut-offs on vDrive and RowFlow systems in this video. This will solve late or early shut-off or turn on as you enter and exit end rows.

CapstanAG Support Videos

CapstanAG: How to check a coil.

This video explains how to check a Capstan coil. Checking your coil will tell you if the coil is bad and cannot be repaired or if the coil is still good and can be repaired. See videos below for details on how to clean a coil.

CapstanAG: How to clean a valve.

Watch this video to learn how to clean a CapstanAg coil. Common flow problems can usually be solved with a good cleaning.

CapstanAG Location Setup

Watch this video to learn how to perform a location setup on your CapstanAg PinPoint II system. This operation should only be performed on initial setup.

CapstanAG Nozzle Setup

Watch this video to learn how to perform a nozzle setup on your CapstanAg PinPoint II system. This operation should only be performed during initial system setup.